Home Up Local Church Intercessions Thanksgivings Psalms
                                      

Home
Up
StrawBale Building
Straw2 Frame
Straw3 Roof
Straw4 Walls1
Staw 5 Walls2
Staw6 Stucco
Straw7 Stucco2
Straw8 Stucco3
Straw9 DryWall
Straw10 Doors

Straw Bale Building Updates - Wall Raising Part2:
Page 5

This is the side door that comes out of one of the bedrooms. Notice that we have 6 mil plastic at the top of the walls and under each door buck for protection against moisture at the top of the bails at those points.
This is the northwest corner of the building. You can see a high 2'x2' window that will provide some light into the corner bedroom. It is high enough to not take any wall space from the room. Remember that each bedroom must have at least one fire escape. A door or window that someone can get out directly to the outside. (If it's a window, then it must be no more than 44" above the floor and have a clear opening of around 5.6sqft which is about a 3"x5" window.)
This is the west side of the building and is where the double front doors will be. We'll be making the doors from 2x6's or 2x8's with lap joints, old fashioned hinges and a lot of prayer.
Inside view of the building. The ceilings are at around 11'6", so there will be plenty of head room.
This is a view of the area where the chapel / multipurpose room will be.
We had several bales left over since we played it safe and didn't want to be short on bales after we purchased them. We are going to use the remaining bales for a decorative wall outside. (Same concept as a house bale wall.)
We have one section of wall that is a traditional 2x6 and sheathing wall. It will be covered in stucco net and stucco like the bale walls. We will eventually connect a future addition to this wall and wanted to make it easy to run water pipes and electricity through it.
The bales are pretty straight but any areas that have too much of a gap or set back will be stuffed with straw. We also have a sledge hammer to make some adjustments to misplaced bales.
Here is a closer view of one of the bedroom window bucks. Whenever possible, we tried to attach the window bucks to a nearby post or the top bond beam of the house for greater stability. This helped them not move as much and might help the stucco around them crack less. They seem to be pretty solid in comparison to if they were just sitting in the straw with pegs and diamond mesh holding them.
Next step, windows and stucco netting (sometimes called chicken wire)!